Water Sanitation & Filtration Kit

WST000

The Water Sanitation and filtration kit blends the application of modern technologies like IoT with traditional filtration process to make innovative projects on water purification, irrigation, recycling, water harvesting, and storage.

  1. Arduino UNO
  2. USB Cable A-to-B
  3. Jumper Wires
  4. Bread Board
  5. IR Sensor
  6. Servo Motor
  7. Raindrop Sensor
  8. RGB LED
  9. Water Level Sensor
  10. Water Pump Module
  11. Motor Driver L293D
  12. Battery
  13. Water Filter System
  14. Sponges
  15. Filter Papers
  16. Crushed Granite
  17. Porcelain Sand
  18. Activated Carbon
  19. Quartz Sand
  20. Sodium Bicarbonate

Do the following tasks:

  1. Check the pH and TDS values of the unfiltered water sample.
  2. Setup the water filtration system
  3. Pour the water sample into the filtration system
  4. Check the pH and TDS values of the filtered water sample.
  5. Calculate the difference between the pH values of the filtered and unfiltered samples
  6. Calculate the difference between the TDS values of the filtered and unfiltered samples

Make your own robotic mop that will scrub the floor clean using Arduino UNO and servo motors. The robotic mop should be able to clean spaces under the bed and sofas.

Do the following tasks:

  1. Build a water filtration system (Challenge 1) that uses the water pump module to get water pumped into it.
  2. The water pump module is controlled by Arduino UNO.

Make a water tap that uses the IR sensor to automatically opens on detecting the hands. The tap system prevents the wastage of water filtered by the water filtration system. 

Make a water pump that can be programmed to run for a specified duration of time. The water pump can be used to pump water into the water filtration system. It can also be used to transfer filtered water to a larger container.